MIL-DTL-44410 Insect Repellent, Clothing Application, Individual Dynamic Absorption Application \(Idaa\) KitThis specification covers one type of IDAA kit for the application of a permethrin insect or arthropod repellent to outer clothing. The kit contains two applications: one for a coat and one for a pair of trousers.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23

MIL-DTL-44410C

3.1.8 Gloves. One pair of disposable polyethylene gloves shall be included. The gloves

shall be sized extra-large and shall fit either hand.

3.2 Assembly of kit. One treatment bag A, one treatment bag B, one pouch containing

two bottles of repellent, two strings, and one pair of gloves shall be placed in each kit bag. The

kit bag shall be closed by heat sealing.

3.3 Labeling. Labeling shall be in compliance with the requirements of 40 CFR 152 of

the Federal Insecticide, Fungicide, and Rodenticide Act, as amended. Labels shall be approved

by the Pesticide Registration Division of the Environmental Protection Agency (EPA).

3.4 Workmanship. The end items shall conform to the quality of product established by

this specification.

3.5 Recycled, recovered, or environmentally preferable materials. Recycled, recovered,

or environmentally preferable materials should be used to the maximum extent possible,

provided that the material meets or exceeds the operational and maintenance requirements, and

promotes economically advantageous life cycle costs.

4. VERIFICATION

4.1 Classification of inspection. The inspection requirements specified herein are

classified as conformance inspection (see 4.3).

4.2 Inspection conditions. Unless otherwise specified (see 6.2), all inspections shall be

performed on a lot. A lot shall consist of the IDAA kits produced by one manufacturer in no

more than 24 hours at one plant from the same materials and under essentially the same

manufacturing conditions, provided the operation is continuous.

4.3 Conformance inspection. The conformance inspection shall be performed in

accordance with the inspection provisions set forth herein. The characteristics shown in 3.1, 3.2,

and 3.3, when tested in accordance with 4.4, shall constitute the minimum inspections to be

performed by the supplier prior to government acceptance or rejection by lot. The absence of any

inspection requirements in the specification shall not relieve the contractor of the responsibility

of assuring that all products or supplies submitted to the government for acceptance comply with

all requirements of the contract. Failure of any test by any sample shall be cause for rejection of

the lot represented.

4.3.1 Sampling. Unless otherwise specified (see 6.2), sampling shall be conducted in

accordance with table I.